Quick Start Guide
WORX
2 in 1 Grass Trimmer/Edger
WG168
CHARGING PROCEDURE
Connect the Charger to an appropriate
power source.
Insert the battery into the Charger:
a) Red Light: Battery is charging.
b) Green Light: Battery is fully charged.
ASSEMBLY INSTRUCTIONS
Assembly of the main handle
Insert the shaft into the upper shaft housing
until a click can be heard. Make sure the
grooves are correctly matched.
Tighten the shaft locking knob in the
direction indicated to lock .
1. Always wear eye protection.
2. Never use the trimmer without the guard in place.
3. Carefully read the operator’s manual before using the trimmer.
4. Wear Long pants to protect your legs
5. Good foot wear is very important
6. Wear gloves when handling the product
www.worxyardtools.com
Accessories
WA0014 Spool
WA3536 Battery pack
WA3734 Charger
We are always here to help you
Please call the WORX helpline to talk to one of our
WORX specialists for additional assistance.
Free Spools for Life
To order your free replacement spools, call
1-866-354-WORX(9679) or visit www.worxyardtools.com
Want more?
Please find out about accessories and the WORX full
range of products at our website.
1-866-354-WORX(9679)
HELPLINE NUMBER
Assembly of the auxiliary handle
Slide the auxiliary handle onto the grooves of auxiliary handle support until a click can be heard.
NOTE:
Make sure the handle is firmly secured in place.
If the handle is loose then tighten the 2 side screws.
Assembly of the safety guard
DO NOT Use this product WITHOUT the Guard being fitted.
a. Remove the screw from the trimmer head.
b. Align the Safety Guard according to the slots on the Trimmer Head so it slides into position.
c. Secure the Safety Guard onto the Trimmer Head with the provided screw.
NOTE: Make sure the guard is firmly secured in place.
Install the battery pack
Once Battery pack is Fully charged –remove
from the charger and install into the
machine as shown in the picture.
NOTE: Keep hands away from
trimmer Start switching levers.
DO NOT--Depress both switch levers
when fitting the battery-as the
machine Will Start.
OPERATION INSTRUCTION
Always remove the battery
pack before adjusting the
trimmer and after use for extra
safety precaution.
Adjustment of auxiliary handle
Release the auxiliary handle locking clamp,
move the auxiliary handle to the most
comfortable and balanced position.
Close the clamp to tighten the handle.
NOTE:
Make sure the handle is firmly
secured in place.
Three speed settings
Your machine is fitted with a 3 Speed
selector button.
Speed 1 - Used for basic light trimming of
short grass.
Speed 2 - Used for medium / longer grass
trimming-ie. trimming against walls/fences
etc.
Speed 3 - Used for tough over grown area’s
of long grass.
4
1
2
2
3
1
2
1
3
4
5
Trimmer Head Rotating
To rotate the trimmer head to edging—first hold the trimmer shaft as shown in the
fig bleow ---then with your other hand hold the trimmer head - Push down and
rotate 180 degrees and then release, the trimmer will then lock into the edging
position automatically.
REPLACE SPOOL OF TRIMMER LINE
Insert the Trimmer Line & Spool Assembly into the Spool Cap with the arrow icons facing
upward.
Trimming
Position the trimmer head shown as the
picture for trimming.
Keep the bottom of the trimmer head just
above the ground and at an angle. Allow
only the COMPONENT LIST tip of line to
make contact. Do not force trimmer line
into work area.
Edging
To convert the Grass Trimmer into the
Edging position, rotate the trimmer head
shown as the step 3 “Trimmer Head
Rotating”.
Position the trimmer head shown as the
picture for edging.
WARNING!
物料号：
尺寸
： X mm，正反印刷，印好后折成A5大小，折叠线不要印出来
材料
颜色：黑+P151C
：100g双胶纸
其他要求：
QSG位置：请折叠平放状态，然后放在包装的最上面，不与说明
书印刷件放在一起，一打开用户就能看到，（还有离裁切线一点距离，避免拆包装时刀片割坏）
正面
(32 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels