Worx WG540 Manuel de service télécharger pdf (Page 10)

18V Cordless Li-ion Blower/Sweeper EN

1110

1110

ASSEMBLY

ASSEMBLING THE BLOWER TUBE

(Fig A1 & Fig A2)

Before assembling the Blower Tube(4), be sure

the on/off switch (2) is in ‘’O’’ Off position.

Fit the Blower Tube to the motor housing as

shown in Fig A1. Check the Blower Tube is

ﬁrmly secured.

WARNING! Do not attempt to operate

or disable the On/Off Switch by any

means other than the normal assembly or

removal of the tube.

NOTE: Before disassembling the Blower

Tube, be sure the on/off switch (2) is in ‘’O’’ Off

position. Press the Release Button(3) , so that

you can separate the tube.(Fig A2)Do not try to

separate the tubes by force or by using tools.

OPERATION

WARNING! The charger and battery

pack are specially designed to work

together so do not attempt to use any other

devices. Never insert or allow metallic objects

into your charger or battery pack connections

because of an electrical failure and hazard will

occur.

1. BEFORE USING YOUR CORDLESS

BLOWER

Your battery pack is UNCHARGED and you

must charge once before use.

The battery charger supplied is matched to the

Li-ion battery installed in the machine. Do not

use another battery charger.

2. CHARGING YOUR BATTERY PACK

The Li-ion battery is protected against deep

discharging. When the battery is empty,

the machine is switched off by means of a

protective circuit: The tool holder no longer

rotates.

In a warm environment or after heavy use, the

battery pack may become too hot to permit

charging. Allow time for the battery to cool

down before recharging.

3. INSTALL THE CHARGER-WA3838

STANDS(WG540.5)(See B)

Slide the two charger stands (a) into the both

grooves on back of the charger. The charger

can stand as shown in Fig.B.

4. HOW TO CHARGE YOUR BATTERY(See

C1/C2)(WG540/WG540.5)

Connect the battery charger (6/7) to the

power supply and the green light (6b/7b) will

illuminate.

Slide the battery pack into the charger to make

the connections (See C1/C2 ).

The green light(6b/7b) will be off. And the red

light(6a/7a) will illuminate to show charging

has started. When charging is completed the

green light(6b/7b) will illuminate while the red

light(6a/7a) is off.

NOTE:

This charger is designed to detect some

problems that can arise with battery pack. (see

table below)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Commentaires sur ces manuels

Pas de commentaire